fiche technique du produit linacure 40
fiche technique de linacure 40 de linatex
Contenu du document
Linacure® 40
Wear resistant uncured rubber for fine slurry applications
Design Features
- Superior wear performance in fine slurry abrasion
- Suitable for hot bonding
- Delivers lowest cost of ownership
- Ideally suited for autoclave curing and compression molding
- 6 month shelf life
Applications
- Pipelines
- Chutes
- Tank linings
- Hoses
Typical Physical Properties
| Property | Test Standard | Linacure® 40 |
|---|---|---|
| Polymer Type | Natural Rubber | |
| Hardness (IRHD) | ISO 48 - 2010 | 40 |
| Modulus @ 500% (MPa) | ISO 37 – 2011 | 3.2 |
| Tensile Strength (MPa) | ISO 37 – 2011 | 21.5 (3118 psi) |
| Elongation at Break (%) | ISO 37 – 2011 | 750% |
| Tear Strength (N/mm) | ASTM D624-00 - 2012 | 43 (245 lbsf/in) |
| Specific Gravity | ISO 2781 - 2008 | 0.95 |
| Resilience (%) | BS 903. Part A8 1990 | 83% |
| Operating Temperatures (continuous use) | -40°C to +70°C / -40°F to +158°F |
Minerals Bonding Systems and Installation
Please consult your local Weir Minerals representative for advice on the most suitable bonding method.
Storage
The shelf life of the Linacure® 40 compound is dependent upon the temperature at which the compound is stored:
6 months at or below 40°C / 104°F. Do not store under direct heat or sunlight.
Size/Availability
Standard Sheet dimensions will vary within each Weir global region. Please contact your local Weir Minerals office to confirm.
Standard thickness range: 3.0mm to 12.0mm (approx. 1/8” to 1/2”)
Copyright © 2019, Weir Minerals Australia Ltd. All rights reserved. WEIR and WEIR (logo) are trademarks and/or registered trademarks of Weir Engineering Services Limited. LINATEX and LINACURE are trademarks and/or registered trademarks of Linatex Ltd. WMD0119/201510
